RADIAL INTERNAL CLEARANCES..... ......CONTINUED

For applications with pure radial loads, a low contact angle or a lesser radial play , is best. For

applications where the bearing will see thrust loads as well as radial loads, a higher contact

angle or radial play will become necessary.

If the application requires a press fit or interference fit on either the inner ring or the outer ring,

or in some cases both, care must be taken to assure that all of the bearings internal clearance is

not taken up by the press fits.

INTERNAL CLEARANCES
B O R E D I A M E T E R d				C2-LESS THAN STANDARD	C0-STANDARD		C3-GREATER THAN STANDARD	C4-GREATER THAN C3
Millimeter		Inches		C L E A R A N C E -- INCHES
Over	Inc.	Over	Inc.	Low High		Low High	Low High	Low High
--	2.5	--	.0984	-- .00024		.0001 .0004	.0004 .0007	-- --
2.5	10	.0984	.3937	-- .00028		.0001 .0005	.0003 .0009	.0006 .0011
10	18	.3937	.7087	-- .00035		.0001 .0007	.0004 .0010	.0007 .0013
18	24	.7087	.9449	-- .00039		.0002 .0008	.0005 .0011	.0008 .0014
24	30	.9449	1.1811	-- .00043		.0002 .0008	.0005 .0011	.0009 .0016
30	40	1.1811	1.5748	-- .00043		.0002 .0008	.0006 .0013	.0011 .0018
40	50	1.5748	1.9685	-- .00043		.00025 .0009	.0007 .0014	.0012 .0020
50	65	1.9685	2.5591	-- .00059		.00035 .0011	.0009 .0017	.0015 .0024
65	80	2.5591	3.1496	-- .00059		.0004 .0012	.0010 .0020	.0018 .0028
80	100	3.1496	3.9370	-- .00071		.00045 .0014	.0012 .0023	.0021 .0033
100	120	3.9370	4.7244	-- .00079		.0006 .0016	.0014 .0026	.0024 .0038
120	140	4.7244	5.5118	-- .00091		.0007 .0019	.0016 .0032	.0028 .0045
140	160	5.5118	6.2993	-- .00091		.0007 .0021	.0018 .0036	.0032 .0051
160	180	6.2992	7.0866	-- .00098		.0008 .0024	.0021 .0040	.0036 .0058
180	200	7.0866	7.8740.	-- .00118		.0010 .0028	.0025 .0046	.0042 .0064